![]() One type of ATF that can be used in a 7.3 Powerstroke is Mercon V. There are a few different types of ATF that can be used in these trucks, so it’s important to consult your owner’s manual or a qualified mechanic to determine the best type for your particular truck. If you own a 7.3 Powerstroke Diesel truck, it’s important to know what type of automatic transmission fluid (ATF) to use in order to keep your transmission running smoothly. 7.3 Powerstroke Automatic Transmission Fluid Type This filter does not hold nearly as much fluid as the internal one but still needs to be replaced any time the main unit is serviced. When performing this service, it’s also important to change the external spin-on filter located on the passenger side of the transmission near where the driveshaft enters it. I have seen some that only hold 10 quarts after a drain and others that held almost 14 quarts! To be safe, always have at least 2 extra quarts on hand just in case you need them. The actual amount of old fluid you get out may vary depending on how well your particular truck has been maintained. If you are changing your own fluid, you will need at least 12 quarts on hand to do a complete flush and fill. When adding fluid to this transmission, it is important to use only Mercon ATF as specified by Ford. ![]() The total capacity for an empty transmission with a new filter is approximately 16 quarts (15 liters). The 4R100 is a heavy-duty transmission and as such, has a large fluid capacity. It was introduced in the 1999 model year behind the 7.3L Powerstroke Diesel engine and was used until 2007 when it was replaced by the 6R140. The 4R100 is a four-speed automatic transmission from Ford. This type of fluid is designed specifically for use in Ford transmissions and should not be replaced with any other type of fluid. The correct transmission fluid for 2002 7.3 Powerstroke is Mercon V. What Kind of Transmission Fluid Does a 2002 7.3 Powerstroke Take? This includes the torque converter and oil cooler. How Many Quarts of Transmission Fluid Does a 4R100 Take?Ī 4R100 transmission takes approximately 11.4 quarts of fluid. This can be found at your local Ford dealership or auto parts store. The 1999 Ford F-250 Super Duty takes ATF+4 Automatic Transmission Fluid. What Kind of Transmission Fluid Does a 99 Ford F2 50 Super Duty Take? You can use a synthetic Dexron III/Mercon fluid, but you should not use a synthetic Mercon fluid. The 4R100 transmission uses a Dexron III/Mercon fluid. However, it’s still a good option if you’re looking for an alternative to Type F fluid. Type CJ fluid is also compatible with Ford transmissions, but it’s not as specifically designed for them.Īs a result, it may not provide as much protection or performance as Type F fluid. It’s also compatible with all other types of Ford transmission fluids, so you can use it if you ever need to top off your fluid level. Type F fluid is specifically designed for Ford transmissions, so it provides the best protection and performance for your truck. The answer is that you can use either Type F or Type CJ fluids in your transmission, but Type F is the preferred choice. If you own a Ford F-150 with a 4R100 transmission, then you may be wondering what type of fluid to use in it. The 4R100 transmission fluid type is Dexron III/Mercon. It is not recommended for use in passenger cars. The 4R100 transmission is a heavy-duty transmission that is designed for use in trucks and SUVs. It is based on the C6 automatic transmission and was used in a wide variety of Ford vehicles. As an Amazon Associate, I earn from qualifying purchases.ĤR100 Transmission Fluid Type The 4R100 transmission is a four-speed automatic transmission that was introduced in 1989.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |